INSTRUCTIONS FOR RAVE BULLDOG, CROSS, SHOULDER HARNESS, ARMBANDS AND SUSPENDERS AND SYNERGY HARNESS
OPERATION:
The harness's battery contains an "on" and "off" switch on the side of the battery. This can be toggled to "on" or "off" position to power up or power down the harness. Once turned into "on" position, the light can be activated by holding the down the button at the center of the battery for 3 seconds. It can easily be seen because the button is raised underneath the Breedwell logo. Once the light is turned on, the button can be pressed to cycle through the different lighting modes. The harness can also be turned off by holding the button down for 3 seconds or by turning the toggle switch at side to "off" position.
The charging port is located at the side of the battery. The port has a cover that slides over to protect it from moisture. Simply slide the protector to the side and plug in the USB charging cable (included) into the battery. Next, plug in the cord into any USB charging port to begin recharging your harness. The battery should take 2 hours to fully charge and an indicator light next to the charging port will turn from red to green to show that charging has been completed. Please do not overcharge your battery as it weakens the it over time, if left on the charger past a full charge.
HOW TO CARE FOR YOUR HARNESS:
The Rave line uses white ribbon, which will dull and yellow over time with use. To keep the ribbon as clean and bright as possible, it is recommended that you apply color-safe fabric detergent with a wet wash cloth to the harness after using or before putting away for a extended time. PLEASE NOTE: Only wash harness straps with a wet wash cloth with detergent (not the battery). We also recommend squeezing out most of the liquid from the wash cloth after soaking it and before applying it to the harness. The harness should NEVER be submerged fully in water or soaked through, as this may damage the battery/lights. Gently apply the detergent to the harness strap in an up/down motion to remove sweat stains/discoloration and odor. Do this for both sides of straps until the harness has been thoroughly cleaned to your liking. After wiping down your harness with a wet wash cloth, we recommend pat drying any excess moisture and laying the harness out to air dry before storing it away. You can also use air freshener to keep any odors away from the harness.
INSTRUCTIONS FOR WARRIOR HARNESS
OPERATION:
To turn harness "on": Toggle the on/off switch on right side of battery, downwards. Harness lights will come on for a second, then go dark, but your harness is active. Use mode selector push button on left side of battery to turn on harness in solid mode, pulse mode or sound-activated mode, in this very order.
To adjust sound-sensitivity in different sound level environments: Turn scroll wheel on right side of battery.
CHARGING, CLEANING, MAINTENANCE: same as our other glow products.
The batteries are located at the end of each light strap. The port to charge the battery is located on the side. Simply flip up the cap cover and plug in the USB charging cable (included) into the battery. Next, plug in the cord into any USB charging port. A red light next to battery port indicates that the battery is charging. When fully charged, the light will turn to green (1.5-2.5 hours). Once your product has been fully charged, please remove the USB cable from the battery and slide the protective cover back on. The cover helps protect the inner electronics from moisture.
WARNING: Do not overcharge your products. Leaving the battery plugged in for longer than needed will damage battery and it won't hold a charge as long as it should.
HOW TO CARE FOR YOUR HARNESS
To clean your harness, apply color-safe fabric detergent with a wet wash cloth. PLEASE NOTE: We strongly recommend that you only wash harness straps with a wet wash cloth. We also recommend squeezing out most of the liquid from the wash cloth after soaking it and before applying it to the harness. The harness should NEVER be submerged fully in water or soaked through as this may damage the battery. Gently apply the detergent to the harness strap in an up/down motion to remove sweat stains and odor. Do this for both sides of straps until the harness has been thoroughly cleaned. After wiping down your harness with a wet wash cloth, we recommend pat drying any excess moisture and laying the harness out to air dry before storing it away.
CHARGING
Every leg strap is equipped with a USB rechargeable battery on each leg. There is a USB port on the side of each battery. USB charging cables are included.
To charge: Simply open the cap on the side of the strap and plug the USB charging cable into the battery. Next plug in the cord into any USB charging port.
While charging, the straps will emit a low light. When they are completely charged, the lights will go out and this is a sign that your leg straps have been fully charged. IMPORTANT: Once your leg straps have been fully charged, please remove the USB cable from the battery and close the the protective cover. The cover protects the inner electronics from moisture. Do not overcharge your leg straps! Leaving the battery plugged in for longer than necessary will weaken your battery over time.
Each leg strap contains a battery charging unit and a lighting component. To activate the light, press on the button on the side of the battery, which controls the 3 glow modes available on each leg strap. The three modes are: solid, fast pulse, and slow pulse. The button is located under the PVC logo patch, on the top of the battery unit. Press firmly against the PVC patch when the leg straps are set to the desired position on your leg.
ADJUSTMENTS
Breedwell leg straps are designed to be adjustable for a wide variety of leg sizes and are specially designed customizable to fit your body type. To tighten or loosen your strap, pull on the logo PVC patch. Simply un-velcro the side and apply the PVC patch to the most comfortable fit for your leg.
Your leg straps were designed to be fully removed from the jock strap to allow you to be able to wash your jockstrap waistband in the laundry machine or to change out the leg straps for different colors, as desired.
How to remove and reattach your leg straps
Leg straps attach to the base of the pouch with a single snap. The snap can be removed with minimal force by pulling the leg straps away from the base pouch. Once the top of the leg straps has been removed, simply un-velcro the tops of the adjustable leg straps and slide through the rings. The leg strap should now be completely separated from the waistband and pouch.
WASH AND CARE
Your leg straps were designed to make wash and care a breeze. Leg straps can be completely removed from the jock strap allowing you to wash your jockstrap waistband in the laundry machine.
WARNING: DO NOT WASH the lighting component of the leg strap. The lighting component MUST be removed from the leg strap. Simply push the battery to the side of the elastic strap and slowly pull out the light from the leg strap. Once the light has been completely removed you can HAND WASH the leg strap in a sink or small bowl with color safe detergent and a wash cloth. DO NOT wash the leg strap in a washing machine or dryer as it will shrink the channel that the light goes in and you will not be able to fit the light and battery back. After hand washing the leg strap, please lay it out on a dry towel and allow it to fully air dry before gently placing the light back into the light channel.
Your jockstrap waistband and pouch are also designed to be machine washable. Simply detach the leg straps completely and wash the waistband/pouch as needed. Please wash the waistband/pouch in cold or warm setting only (do not use HIGH heat) and dry using low heat setting. Once they have been washed you can then reapply the leg straps and wear them out for your next event.
OPERATION
The pouch can be applied to the jockstrap by aligning the jockstrap with the snaps and pressing them into place using slight force. Slight force can also be used to remove your pouch from the waistband.
The button to control the lighting modes is located on top of the battery unit, under the PVC logo patch. Simply press the center of the PVC patch to switch between the 3 lighting modes or to turn off your pouch.
CHARGING
The battery is located at the base of the pouch. The battery contains the USB rechargeable battery. The port to charge the battery is located on the side of the battery. Simply flip up the cap covering the battery and plug in the USB charging cable (included) into the battery. Next plug in the cord into any USB charging port. The pouch will emit a low light while charging and when completely charged, the light will go out. This is how you know your pouch has been fully charged. Once your pouch has been fully charged, please remove the USB cable from the battery and slide the protective cover back on. The cover helps protect the inner electronics from moisture.
WARNING: Do not overcharge your pouch. Leaving the battery plugged in for longer than needed will weaken your battery's life over time.
WASH AND CARE
Your GLOW POUCH is fully removable from the jock strap, allowing you to wash your jockstrap in the laundry machine. WARNING: DO NOT wash the lighting component of the Glow Pouch. The lighting component should be removed from the pouch. Simply push the battery to the side of the pouch and slowly pull out the battery and lighting component from the pouch. Once the light has been completely removed, you may HAND WASH the pouch in a sink or small bowl with color-safe detergent. WARNING: Do not wash the pouch in a washing machine or dryer, as it will shrink the channel that holds the lighting component and you will not be able to fit the light and battery back into the pouch. After hand washing the pouch, lay out the pouch and allow it to fully air dry before gently placing the it back into the light channel.