My Cart

Close

USER GUIDE

INSTRUCTIONS FOR RAVE BULLDOG, CROSS, SHOULDER HARNESS, ARMBANDS AND SUSPENDERS

OPERATION: 

The harnesses battery contains a on and off switch on the side of the battery, This can be toggled to on or off position to power up or power down the harness. Once turned into on position the light can then be activated by holding the down the button at the center of the battery for 3 seconds. It can easily be seen because the button is raised underneath the breedwell logo. Once light is turned on the button can be pressed to cycle through the different lighting modes. The Harness can also be turned off by holding the button down for 3 seconds or by turning the toggle switch at side to off position.

The charging port is located at the side of the battery. The port has a cover that slides over it to protect from moisture. Simply slide the protector to the side and plug in the USB charging cable (included) into the battery. Next plug in the cord into any USB charging port to begin recharging your harness. The battery should take 2 hours to fully charge and an indicator light next to the charging port will turn from red to green to show that charging has been completed. Please do not overcharge your battery as it weakens the battery over time if left on the charger past a full charge.

HOW TO CARE  FOR YOUR HARNESS:

The rave line uses white ribbon, which will dull and yellow over time with use. To keep the ribbon as  clean and bright as possible  it is recommended that  you apply color-safe fabric detergent with a wet wash cloth to the harness after using or before putting away for a extended time . PLEASE NOTE: Only wash harness straps with a wet wash cloth with detergent ( not the battery) . We also recommend squeezing out most of the liquid from the wash cloth after soaking it and before applying it to the harness. The harness should NEVER be submerged fully in water or soaked through as this may damage the battery/lights. Gently apply the detergent to the harness strap in an up/down motion to remove sweat stains/discolorations and odor. Do this for both sides of straps until the harness has been thoroughly cleaned to your liking. After wiping down your harness with a wet wash cloth, we recommend pat drying any excess moisture and laying the harness out to air dry before storing it away. You can also use air freshner to keep any odors away from the harness.

INSTRUCTIONS FOR NIGHTCRAWLER FACE MASK

OPERATION: 

The mask contains 2 batteries on both sides of the mask. To turn the mask on or off simply press down on the center of BW logo sticker on the battery for 2-3 seconds. Once mask is on you can shift through the color modes by pressing down the sticker for 1 second. 

The batteries are located at the end of each side of the mask with the BW logo stickers. The port to charge the battery is located on the side . Simply plug in the USB charging cable (included) into the battery. Next plug in the cord into any USB charging port. The mask should take 2 hours to fully charge. Please do not overcharge as it weakens the battery over time

HOW TO CARE  FOR YOUR MASK

To clean your face mask, use apply color-safe fabric detergent with a wet wash cloth. PLEASE NOTE: We strongly recommend that you only wash facemask with a wet wash cloth. We also recommend squeezing out most of the liquid from the wash cloth after soaking it and before applying it to the mask. The mask should NEVER be submerged fully in water or soaked through as this may damage the battery Gently apply the detergent to the mask in an up/down motion  to remove odor or stains . Do this for both sides of mask until the mask has been thoroughly cleaned to your liking. After wiping down your mask with a wet wash cloth, we recommend pat drying any excess moisture and laying the mask out to air dry before storing it away.

INSTRUCTIONS FOR WARRIOR HARNESS

OPERATION: 

To turn harness on : Toggle the on/off switch on right side of battery downwards. Harness lights will come on for a second, then goes dark but your harness is active. Use mode selector push button on left side of battery to turn on harness in solid mode, or pulse mode or sound-activated mode in this order

To adjust sound-sensitivity in different sound level environments: Turn scroll wheel on right side of battery.  

CHARGING, CLEANING, MAINTENANCE: same as our other glow products.

INSTRUCTIONS FOR GLOW HARNESSES, ARMBANDS
CHARGING
The batteries are located at the end of each light strap. The port to charge the battery is located on the side . Simply flip up the cap cover  and plug in the USB charging cable (included) into the battery. Next plug in the cord into any USB charging port. A red light next to battery port indicates, , battery is charging.  When fully charged,the light will turn to green (1.5-2.5 hours). Once your product has been fully charged, please remove the USB cable from the battery and slide the protective cover back on. The cover helps protects the inner electronics from moisture.
WARNING: Do not overcharge your products. Leaving the battery plugged in for longer than needed will damage battery and it wont hold a charge as long as they should.
 
HOW TO CARE  FOR YOUR HARNESS
To clean your harness, use apply color-safe fabric detergent with a wet wash cloth. PLEASE NOTE: We strongly recommend that you only wash harness straps with a wet wash cloth. We also recommend squeezing out most of the liquid from the wash cloth after soaking it and before applying it to the harness. The harness should NEVER be submerged fully in water or soaked through as this may damage the battery Gently apply the detergent to the harness strap in an up/down motion  to remove sweat stains and odor. Do this for both sides of straps until the harness has been thoroughly cleaned to your liking. After wiping down your harness with a wet wash cloth, we recommend pat drying any excess moisture and laying the harness out to air dry before storing it away.
INSTRUCTIONS FOR GLOW AND RAVE JOCKSTRAP SYSTEM

CHARGING

Every leg strap is equipped with a USB rechargeable battery on each leg. There is a USB port on the side of each battery.  USB charging cables are included.

To charge: Simply open the cap on the side of the strap and plug the USB charging cable into the battery. Next plug in the cord into any USB charging port.

While charging, the straps will emit a low light. When they are completely charged, the lights will go out and this is a sign that your leg straps have been fully charged. IMPORTANT: Once your leg straps have been fully charged, please remove the USB cable from the battery and close the the protective cover. The cover protects the inner electronics from moisture. Do not overcharge your leg straps! Leaving the battery plugged in for longer than necessary will weaken your battery over time.
OPERATION
Each leg strap contains a battery charging unit and a lighting component. To activate the light, press on the button on the side of the battery, which controls the 3 glow modes available on each harness. The three modes are: solid, fast pulse, and slow pulse. The button is located under the PVC logo patch, on the top of the battery unit. Press firmly against the PVC patch when the leg straps are set to the desired position on your leg.

ADJUSTMENTS
Breedwell leg straps are designed to be adjustable for a wide variety of leg sizes and is specially designed so that you can customize it to fit your body type. To tighten or loosen your strap, pull on the logo PVC patch. Simply un-velcro the side and apply the PVC patch to the most comfortable fit for your leg.

Your leg straps were designed to be fully removed from the jock strap to allow you to be able to wash your jockstrap waistband in the laundry machine. Or to change out the leg straps for different colors as desired.

How to remove and reattach your leg straps
Leg straps attach to the base of the pouch with a single snap. The snap can be removed with minimal force by pulling the leg straps away from the base pouch. Once the top of the leg straps has been removed simply un-velcro the tops of the adjustable leg straps and slide through the rings. The leg strap should now be completely separated from the waistband and pouch.  

WASH AND CARE
Your leg straps were designed to make wash and care a breeze. Leg straps can be completely removed from the jock strap, allowing you to wash your jockstrap waistband in the laundry machine.  

WARNING: DO NOT WASH the lighting component of the leg strap. The lighting component MUST be removed from the leg strap. Simply push the battery to the side of the elastic strap and slowly pull out the light from the leg strap. Once the light has been completely removed you can HAND WASH the leg strap in a sink or small bowl with color safe detergent and a wash cloth. DO NOT wash the leg strap in a washing machine or dryer as it will shrink the channel that light goes in and you will not be able to fit back in the light and battery. After hand washing the leg strap, please lay out the leg strap on a dry towel and allow it to fully air dry before gently placing the light back into the light channel.

Your jockstrap waistband and pouch are also designed to be machine washable. Simply detach the leg straps completely and wash the waistband/ pouch as needed. Please wash the waistband/pouch in cold or warm setting only (do not use HIGH heat)  and dry using low heat setting. Once they have been washed you can then reapply the leg straps and wear them out for your next event.
INSTRUCTIONS FOR GLOW AND RAVE POUCH

OPERATION
The pouch can be applied to the jockstrap by aligning the jockstrap with the snaps and pressing them into place using slight force. Slight force can also be used to remove your pouch from the waistband. 
The button to control the lighting modes is located on top of the battery unit under the PVC logo patch. Simply press the center of the PVC patch to switch between the 3 lighting modes or to turn off your pouch.

CHARGING
The battery is located at the base of the pouch. The battery contains the USB rechargeable battery. The port to charge the battery is located on the side of the battery. Simply flip up the cap covering the battery  and plug in the USB charging cable (included) into the battery. Next plug in the cord into any USB charging port. The pouch will emit a low light while charging and when completely charged, the light will go out. This is how you know your pouch has been fully charged. Once your pouch has been fully charged, please remove the USB cable from the battery and slide the protective cover back on. The cover helps protects the inner electronics from moisture.

WARNING: Do not overcharge your pouch. Leaving the battery plugged in for longer than needed will weaken your battery life over time.

WASH AND CARE
Your GLOW POUCH is fully removable from the jock strap, allowing you to wash your jockstrap in the laundry machine. WARNING: DO NOT wash the lighting component of the Glow Pouch. The lighting component should be removed from the pouch. Simply push the battery to the side of the pouch and slowly pull out the battery and lighting component from the pouch. Once the light has been completely removed, you may HAND WASH the pouch in a sink or small bowl with color-safe detergent. WARNING: Do not wash the pouch in a washing machine or dryer as it will shrink the channel that holds the lighting component and you will not be able to fit the light and battery back into the pouch. After hand washing the pouch, lay out the pouch and allow it to fully air dry before gently placing the light back into the light channel.